Minelab Excalibur II Manual de Instruções Página 10
- Página / 23
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
14 15Charging the Battery Pack
Low Battery Alarm
When the batteries are nearing depletion, the threshold will gradually
increase to a loud continuous signal. This tone identifies that the NiMH
battery pack needs to be recharged or the alkaline batteries need to be
replaced. A fully charged battery pack ensures optimum performance.
The Excalibur II is supplied with a sealed battery pack
which contains 10 NiMH rechargeable cells. This pack
has been pressure tested to a depth of 66 m (200ft)
which makes it suitable for both land and underwater
detecting.
The batteries can be recharged without having to
remove them from the pack .
The Excalibur II is also supplied with an adaptor plug
and a mains charger (240v/230v/110v). The charger will
charge the batteries from local mains (AC) power outlets.
1 Unplug the battery cable from the battery pack (you
can leave the battery pack on the shaft).
2 Connect the charger into the adaptor plug.
3 Connect the adaptor plug to the battery pack using
the guide screw to align the battery contacts correctly.
4 Plug the charger into a power socket. For its first time,
allow the battery to charge for at least 16–17 hours
to ensure its peak performance while detecting.
A fully charged battery pack should provide you with
14–19 hours of detecting time.
An extra NiMH battery pack can also be purchased
separately as an accessory item.
Alkaline Battery Pack (Available as an accessory)
The alkaline pack is water resistant but not waterproof
so is suitable for land and beach shallow-wading only.
This pack is not sealed and must be opened to replace
the batteries.
Replacing Alkaline Batteries:
1 Ensure that the detector is switched off
before opening the alkaline battery pack.
2 Remove the cap of the battery pack.
3 Remove the battery cell compartment from
the battery pack and take out the
old batteries.
4 Install the new batteries, orientating the
positive (+) and negative (–) as shown.
5 Replace the compartment and the
battery pack cap.
Always use good quality alkaline batteries.
Rechargeable NiMH batteries cannot be used
in the Alkaline pack, as they do not provide
sufficient voltage.
- Quick Start 1
- WWW.MINELAB.COM 2
- 1Congratulations 3
- Minelab Excalibur II 3
- Contents 4
- How Metal 5
- Detectors Work 5
- 6 7List of Parts 6
- Assembly 6
- 10 11Assembly 8
- Adjusting the Detector 9
- 16 17Detecting Basics 11
- Common Terms 11
- Turning the 12
- Detector On 12
- Control Panel 12
- A Detecting Exercise 13
- Audio Level 14
- Threshold 14
- Adjusting the Background 14
- Protect your ears! 15
- Some Coins 16
- 18K Gold Rings, Brass 16
- Copper, Lead, Some Coins 16
- 28 29Discriminate 17
- Rejecting Unwanted Targets 17
- Pinpointing 18
- Locating the Target 18
- Recovering the Target 19
- Taking Care 20
- Troubleshooting Technical 21
- Specifications 21
- Warranty 22
- Accessories 22
- Description of Fault 23
- Service Repair Form 23
Manuais e produtos relacionados com Medição, teste e controlo Minelab Excalibur II
(47 páginas)
(94 páginas)
Medição, teste e controlo Minelab F3 Especificações
(44 páginas)
(44 páginas)
(11 páginas)Samsung SHU-D6000S manuals
Owner’s manuals and user’s guides for Unknown Samsung SHU-D6000S.
We providing 1 pdf manuals Samsung SHU-D6000S for download free by document types: User Manual
Comentários a estes Manuais