Minelab F3 Manual de Serviço descarregar pdf (Página 27)

a. Disabling and Enabling LED Display. The F3L factory pre-set

is LED display enabled but this feature can be disabled or

enabled as follows:

•

••

• Disable. With the detector switched on, to disable the LED

display, press and hold the button and simultaneously, quickly

press and release the green Ground Balance button.

NOTE

Once the LED display is disabled, unless subsequently enabled, the

LEDs will remain extinguished even if the detector is repeatedly

switched off and on.

• Enable. With the detector switched ON, to enable the LED

display, press and hold the button and simultaneously, quickly

press and release the green Ground Balance button.

NOTE

Once the LED display is enabled, unless subsequently disabled, the

LEDs will be illuminated whenever the detector is switched on.

If an Earset Speaker OFF is connected to the detector, the LED

display will be automatically disabled for tactical reasons. However,

if required the LED display can be enabled as described above.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 48 49

Sem comentários

Minelab F3 Manual de Serviço Página 27