Minelab Quattro MP Especificações descarregar pdf (Página 6)

2. assembling your detector

2. Assembling Your Detector

To assemble your Minelab Quattro MP,

follow steps 1 to 4 below.

Step 1 - Connecting the Search Coil

To attach the search coil to the lower shaft:

1. Plug the two rubber washers (1) into the holes on either

side of the coil yoke (2).

2. Place the search coil (3) on a flat surface with the front of

the coil facing away from you, and check that the open side

of the yoke is facing the ground.

3. Slide the yoke into the yoke bracket on top of the coil.

4. Insert plastic bolt (4) through the search coil’s yoke

bracket and the coil yoke. Fasten with the yoke

nut (5) provided, being careful not to damage the thread

of the nut by over-tightening. This may need to be

loosened to adjust the coil to a comfortable detecting angle.

Caution: DO NOT attempt to disconnect the coil cable where

it enters the search coil itself as this cable is direct wired into the

coil and is not dismountable. Any attempt to disconnect this

cable will void your coil warranty.

Step 2 - Shaft Assembly

1. Release the shaft camlock lever (6) before

inserting the lower shaft (7).

2. Feed the coil cable (8), which is inside the lower

shaft all the way through the inside of the upper shaft (9).

Make sure the longer side of the bevelled shaft (10)

is at the back of the control box.

Note: When exchanging the

standard coil with an accessory coil

like the 8", it may be easier to pull

the cable through the lower shaft

using a length of string or cord.

Once this is completed you should

be able to see approximately 4 inches

(100mm) of cable between the coil yoke

and the search coil. This is the slack

necessary to allow adjustment to the angle

of the search coil.

3. Slide the lower shaft entirely into the upper shaft until the camlock

rests against the yoke.

4. Pull the coil cable’s metal connector (11) through the open end of the upper shaft

until it ‘dangles’ from the opening.

www.minelab.com

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comentários a estes Manuais

Sem comentários

Minelab Quattro MP Especificações Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Minelab Quattro MP