Minelab F3 Manual de Serviço descarregar pdf (Página 26)

F3 Field Service Manual

Page 26

Figure 33: Recess for Earset Plug Dustcap

● Carefully fit the left handle half to the right handle half and upper shaft. Ensure both

halves are secured to the upper shaft.

NOTE

Hold the handle together tightly until the first two bolts have been fitted otherwise the internal

nut or main wiring loom may become dislodged. The four bolts should initially only be done

up loosely.

● Tighten the four bolts.

3.7 Wiring Loom. To remove and exchange the wiring loom, it is necessary to remove

the speaker pod, disassemble the handle and disconnect the electronics pack from the

upper shaft.

a. To remove the speaker pod, follow the instructions given in Section 3.5.a.

b. To disassemble the handle, follow the instructions given in Section 3.6.a.

c. To disconnect the electronics pack, refer to Figure 34 and proceed as follows:

1 8007-0023 UPPER SHAFT BLACK F3

2 9511-0097 WIRING LOOM F3 SHAFT/HANDLE

3 COIL CABLE (PART OF 2021-0054 COIL F3)

4 8009-0007 RETAINER PLUG F3

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 41 42

Sem comentários

Minelab F3 Manual de Serviço Página 26