Minelab F3 Manual de Serviço descarregar pdf (Página 29)

F3 Field Service Manual

Page 29

Figure 38: Correct Fitting of the Wiring Loom into the Electronics Pack

NOTE

Take great care when connecting the wiring loom plug to the electronics pack. DO NOT

force the connection because this could damage or break the connector on the printed

circuit board.

● Fold excess main wiring loom cable into the electronics pack above the plug. (Figure

39)

Figure 39: Excess Wiring Loom Cable Folded Correctly

● Refit the bulkhead cover with six screws.

● If necessary, apply a light covering of silicone grease to the split grommet and fit it

into the opening on the bulk head cover (Figure 40) and secure it into place with the

ribbon cover and two screws.

Figure 40: Split Grommet & Bulk Head Cover Opening

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

Sem comentários

Minelab F3 Manual de Serviço Página 29