Minelab F3 Manual de Serviço descarregar pdf (Página 36)

F3 Field Service Manual

Page 36

e. To reassemble the middle camlock assembly:

● Using Figure 50 as a guide, attach the two collar shafts (Part 3) to the rear of the

middle shaft.

er Shaft

3004-0008

MIDDLE SHAFT KIT SVC BLACK

1 3004-0012 CAMLOCK KIT MIDDLE SHAFT

(not shown – see next figure)

2 8007-0024 MIDDLE SHAFT BLACK F3

3 8003-0019 COLLAR SHAFT MIDDLE F3

Figure 50: Fitting the Middle Shaft

● Slide the middle shaft into the rear of the upper shaft with the square hole facing

down.

● Place the tail of the middle pressure block into the recess in the front of the middle

camlock body and push the block into the square hole.

● Refit the cam lever and cam lever pivot pin. (Figure 51)

NOTE

Ensure that the pressure block does not protrude too far into the shaft. If required, push it

back into the camlock body otherwise difficulty may be encountered when fitting the lower

shaft.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42

Sem comentários

Minelab F3 Manual de Serviço Página 36