Minelab F3 Manual de Serviço descarregar pdf (Página 27)

F3 Field Service Manual

Page 27

5 COIL PLUG (PART OF 2021-0054 COIL F3)

6 3004-0036 ELECTRONICS PACK KIT SVC F3L

6 3004-0001 ELECTRONICS PACK KIT SVC F3

7 4003-0101 SCREW M3x20 SKT CAP

8 4309-0039 O-RING BULKHEAD 50MM

9 0703-0095 COVER BULKHEAD F3

10 4003-0084 SCREW NO 3X16 POSI SS

11 4003-0084 SCREW NO 3X16 POSI SS

12 4309-0044 GROMMET BULKHEAD F3

13 0703-0097 COVER RIBBON CABLE F3

Figure 34: Electronics Pack

NOTE

The F3 and F3L use different electronics packs and should not be interchanged unless the

correct speaker pods (F3L requires the speaker pod with LED display) are also fitted.

● Remove battery pack and sensitivity endcap.

● Undo and remove the two screws (Part 11) holding the ribbon cable cover (Part 13)

to the bulkhead cover (Part 9).

● Carefully pull back the ribbon cable cover releasing the split grommet (Part 12) from

the bulk head cover.

● Undo and remove the six screws (Part 10) holding the bulkhead cover (Part 9) to the

electronics pack rear panel.

● Pull the bulkhead cover away from the electronics pack.

● Gently unplug the wiring loom plug from the electronics pack printed circuit board.

(Figure 35)

Figure 35: Removal of Wiring Loom from Electronics Pack

NOTE

Extreme care must be taken when removing the wiring loom plug from the electronics pack.

DO NOT use excessive force as this may cause damage to the connector on the printed

circuit board.

● Undo and remove the upper two screws (Part 7) securing the electronics pack to the

upper shaft.

● Slide the electronics pack back along the upper shaft (avoid snagging the wiring

loom) approximately 10cms (4ins).

● Remove the bulk head cover (Part 9), split grommet (Part 12) and ribbon cover (Part

13) from the wiring loom.

NOTE

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 41 42

Sem comentários

Minelab F3 Manual de Serviço Página 27